Chapter 1 Exploded 65% (In-stock)

FIRMWARE AND INSTRUCTIONS (thanks to Cheezi aka Flash3ds Left Kidney on Proph's discord)

DON'T FORGET TO PICK UP EXTRAS!

BUILD STREAM (ALEXOTOS) | BUILD STREAM (MECHMERLIN) | DUTCHMASTERW

Quality Disclaimer

• Internal streaks, blemishes and uneven anodizations that are not visible after being built are within QC expectations.
• Pictures may be different than actual products due to variations of lightings. However, the designer has tried his best to capture all the finishing.

Introduction

• Chapter 1 was designed to honor the material used, by making these materials visible in a sophisticated and striking way.
• This is done by easily making all parts that make up the board visible in one way or another; allowing for nearly endless ways to mix and match plates, knobs, weights and your own keycaps to achieve a build that is truly what you want!
• The single piece weight spans across the width of the board that creates an amazing sound - specifically for the alphas with the higher density of brass, copper or a stainless steel weight! 
• The custom knob was designed to match the aesthetics of Chapter 1 and brings a totally new look and feel to keyboards with knobs!
• The leaf spring plate was designed to achieve a bouncier, softer typing feel rather than being flexy. This effect works perfectly on PC and aluminium plates, with brass and copper naturally being a much stiffer.

Specifications

• 65%
• Isolation gasket mount with leaf spring plate
• 6.5° typing angle
• 18mm front height (excluding front chamfer)
• Footprint = 340mm wide x 136.5mm deep
• Weight is between 1.8kg and 2.5kg depending on configuration
• Arrow cluster
• EC11 Rotary encoder (NOT PRE-SOLDERED ON SOLDER PCB)
• ANSI and ISO plate options (6.25u only)
• Solder and Hotswap PCBs
• USB-C daughter board
• Aluminium and Polycarbonate Case Options
• Various Weight Options
• Custom Knob

Package

• Top, bottom and weight
• PC plate as standard (ANSI/ISO)
• Knob matching chosen edition
• Hotswap/solder PCB + jst + db + rotary encoder
• Daughterboard and encoder
• Necessary screws
• Gaskets, feet and silicon plate alignment pins
• Hard carry case
• Chapter 1 comic